Disabled Parking Area Rubber Wheel Stops

Our rubber wheel stops have are available with blue chevrons designed specifically for Disabled Parking Bays. These have been designed as an economical and durable alternative to the cumbersome concrete style.

Our rubber wheel stops weighs approximately 18kg against nearly 60kg for concrete. This means one person alone can install our wheel stops against two people with lifting equipment for its concrete counterpart, a considerable cost saving.

The wheel stop is moulded from a tough recycled rubber compound and is finished with the standard blue disabled parking hazard pattern. It is 1650mm long and 100mm high to comply with the recently updated Australian standard AS2890.1.

There are three 20mm diameter fixing points for each wheel stop, recessed to hide the fixings. The unit can be supplied complete with fixings, simply specify the type of surface, concrete or bitumen. Ask about our installation service to have your wheel stops installed to meet Australian standards.

Additional Benefits:

Complies with recently updated Australian standard AS2890.1
Far Lighter (18.0kg) than its concrete counterpart.
Easy and safe installation by one person
Easy and economical to transport
Highly visible, distinctive yellow markings
Also available with yellow chevrons for general parking spaces
Economical to transport, cheaper than concrete. Can be shipped nationally
Forklift or hand unload, easy to move multiple units around a site
Can be lifted and installed by one person (versus two men for concrete)
Lightweight and easy to move, halving the installation time

Available in Two Colours:

Technical Specifications:

Part No.	Length	Width	Height	Weight	Colour
PWS1650	1650mm	159mm	100mm	18.0kg	Yellow Chevrons
PWS1650	1650mm	159mm	100mm	18.0kg	Blue Chevrons
FXWS/CR	Wheelstop fixings for concrete, pack 3
FXWS/BR	Wheelstop fixings for bitument, pack 3

	Plastic Wheelstops with chevrons
	Plastic Wheelstop no Chevrons
	Rubber Wheelstops
	Disabled Wheelstops
	Vehicle Management